It is no doubt that the Peloton shoe is just as expensive as the bike, at least when compared to its market competitors. Therefore, it is obvious that you will want the best maintenance procedure for them, regardless of how tasking.
The good news is that how to clean Peloton shoes is just as simplified as the task itself. Over and above that, we will dive into the specifics of deodorizing the shoes, ensuring that your shoes are not only clean but fresh.
How to Clean Peloton Shoes?
One advantage of the peloton shoe over outdoor cyclists is that the shoe will rarely be dirty. Therefore, you don’t have to clean it deeply after every other ride.
Also, you can’t walk in peloton shoes because the cleats protrude at the bottom while the sole is very smooth. This also protects the shoes from additional dirt to your advantage.
So, here’s a suitable guide;
After Every Ride:
Get a wet piece of cloth or a soft towel and wipe the shoes on the outside to keep them clean. If you get overly sweaty after every ride, consider an odor-removing powder. Some people find success with baking soda and vinegar, which are readily available.
However, you can also get an odor-absorbing spray or powder from shoe stores and the like. Spray or put the powder in the shoes after the ride, then leave them to dry. Do not sun-dry the shoes, because the harsh sun rays may cause hardening on the shoes.
Occasionally
However, after a spectrum of rides, you should take time to give your peloton cycling shoe a thorough clean.
You will need the following;
- Warm water
- A washing cloth/ soft towel
- An old toothbrush
- A shoe detergent
- A soft brush
Step 1: Unbuckle the Shoes
First, unbuckle the shoes, and loosen the Velcro straps as well. This process will help reach the toe area of the shoe successfully. Besides, the shoe will aerate better with the straps loose.
Step 2: Add Detergent to Water
If you have the shoe detergent, you have a better shout at friendly washing detergent. However, you can as well use diluted dishwashing detergent, which you add to warm water in a bucket.
Step 3: Clean the Shoes
Dip the shoes in the mixture and allow each part of the shoe to fill with water. Leave them for a few seconds, which will allow the shoes to wet enough for the wash.
Take the soft brush and scrub the interior gently. Then, head to the top side, where you will pay attention to the mesh parts. The mesh parts will not clean thoroughly even after a wipe, hence the necessity for scrubbing.
Go through the whole upper part, and also give preference to the shoe opening. Then, scrub the Velcro straps and the shoe tongue.
Now let’s head to the shoe bottom, where you will switch brushes. Use a rough brush or an old toothbrush dipped in the detergent mixture and brush the shoe bottom. Consider giving special attention to the cleat area, which could have some hidden elements. Scrub the area thoroughly.
Remove the insoles and scrub them well with the soft brush to get rid of all sweat and moisture absorbed from your feet during the rides.
Step 4: Rinse the Shoes
Bring in another basin of water, and put the shoes in the water to rinse off the detergent. If possible, run tap water on the shoes for a sure rinsing process.
Then, run the insoles in the tap water, ensuring that the cleaning didn’t leave a stain behind.
Step 5: Dry the Shoes
Since you cannot dry the shoes in direct sunlight, the process may take longer. To fasten it, put some crumpled newspaper in the shoes to aid drying. Then, put the shoes in a warm area or near a fan.
There are also shoe powders that help in quicker drying so that you can use one as well with the peloton shoes.
Step 6: Deodorize the Shoes
Once the shoes are dry, put back the insoles and spray some deodorant in the shoes. This spray or powder will help prevent odor after your next ride.
Step 7: Keep the Shoes Ready for the Next Ride
Check whether the cleats loosened during the cleaning process, and tighten them. Remember that the cleats should be tight before any ride to prevent them from sticking in the pedal platform.
Then, adjust the Velcro straps and the buckle strap so that all you have to do during your session is slide into the fresh shoes.
The Don’ts on How to Clean Peloton Shoes
[su_list icon=”icon: close” icon_color=”#d8072c”]
- Never wash your peloton shoes in the washing machine, as this will damage the shoe structure.
- Don’t use a harsh detergent on the shoes, which could facilitate peeling off or fading away of color.
- It will frustrate you if you use a firm bristle brush on the shoe, especially the upper shoe. The brush could cause scratches and damage to the shoe material.
[/su_list]
Frequently Asked Questions (FAQs)
Do Peloton shoes stink?
Yes, they do, but not as much. If you sweat too much, they will obviously stink. However, with a deodorizing plan, this should never pose a challenge.
Can you machine wash the peloton shoes?
It is not advisable to wash the shoes in the washing machine. However, if you have to, wrap them in a towel and give them a gentle wash. Don’t dry them in the machine, though, as this will cause utter damage.
Are Peloton shoes worth it?
Yes, they are. They are the best shot you have at peloton-compatible shoes, as you don’t have to waste time researching them. Moreover, they are of high quality, just as the bike.
Bottom Line
If you had a problem with how to clean Peloton shoes, you now got the answer. They are not as complicated as you would imagine, as long as you know what to do. And, you now know what to do, right?
You can confidently ride on your shoes, knowing too well that you got a cleaning plan up your sleeves.
Read Also: